Leaf Razor Grip Sleeve
Shipping calculated at checkout.
This silicone sleeve fits The Leaf razor, providing additional grip. It is custom molded out of silicone to fit the handle perfectly. You can slide it on, and remove it whenever you like.
1. Wet your razor handle and apply a small amount of soap to the handle to get it slick. Wet the inside of the grip sleeve.
2. Wrap a towel around the sleeve so that you can get a good grip on it. Position the small end of the grip at the bottom of the razor handle and push it on. Wrap a cloth around the wet grip to make pulling it up easier. Bring it to the bottom of the "Y" at the peak of the handle.
3. Once positioned, rinse the soap-assist clean. Run water through the grip sleeve on the handle, inside the top, through the bottom, and through the sides. Keep rinsing until you feel the grip holding the handle instead of sliding around. Let it dry a bit, the sleeve should be firmly grabbing the handle now.
I think that Leaf should either include this grip or design a textured handle, but until they do, I highly suggest adding it on. The razor can be really hard to hold when it is wet and soapy, and this helps.
I love my leaf razor but using it with soap and water in the shower, it can get a little slippery. The grip sleeve is a must and makes shaving much easier.
This made my shaving routine a whole lot easier. Sometime my leaf razor would slip out of my hand in the shower so this grip sleeve has helped a ton with that. I highly recommend is you use a Leaf razor!